WarmlyYours nSpiration Thermostat Tempzone Single wiring Diagram Guide

WarmlyYours nSpiration Thermostat Tempzone Single wiring

For 120V & 240V Single Conductor TempZone with nSpire Touch Wi-Fi (UWG4), nSpire Touch (UDG4), nHance (UDG), nTrust (UTN4), nJoin (USG)

ELECTRICAL ROUGH-IN

FACEPLATE REMOVAL

REAR OF THE BASE

1. MAT HAS NO POLARITY
2. RED OR YELLOW INDICATORS ON COLD LEAD INDICATE THE “BEGINNING” OF THE MAT. WHITE INDICATORS SIGNIFY THE “END” OF THE MAT
3. COLD LEAD IS 13” AT “THE BEGINNING” OF THE MAT, AND 26’ AT “END” OF THE MAT (20’ & 40’ LEADS ON 3’ WIDE MATS)
4. ENSURE THAT ALL COLD LEADS PRESENT IN THE THERMOSTAT BOX ARE THE SAME DIAMETER
5. DO NOT SHORTEN THE MAT
6. DO NOT CUT THE HEATING WIRE
7. ALWAYS TEST OHMS OF ROLE BEFORE, DURING, AND AFTER INSTALLATION
8. ALWAYS TEST THE SENSOR AND VERIFY 8-15 K OHM RESISTANCE
9. NEVER INSTALL ELECTRIC FLOOR HEATING UNDER PERMANENT FIXTURES
10. THE INSTALLATION MUST COMPLY WITH ALL NATIONAL AND LOCAL ELECTRICAL AND BUILDING CODES, INCLUDING AUTHORITY HAVING JURISDICTION.

Installation Support • (800) 875-5285 • www.WarmlyYours.com

REFERENCE

Download Manual

WarmlyYours nSpiration Thermostat Tempzone Single wiring Diagram Guide

Other Manual

WarmlyYours nSpiration Thermostat Wiring Diagram Guide

WarmlyYours nSpiration Thermostat Environ Wiring Diagram Guide

WarmlyYours nSpiration Thermostat Slab Heating Wiring Diagram Guide

WarmlyYours nSpiration Thermostat Tempzone Twin wiring Diagram Guide

WarmlyYours nSpiration Thermostat Tempzone Single Wiring Diagram Guide