VIVE Comfort TP-W150W Thermostat INSTALLATION MANUAL

VIVE Comfort TP-W150W Thermostat

IVE Comfort
1111 S. Glenstone Ave., Suite 2-100
Springfield, MO 65804
Toll-Free: 1-800-776-1635 Web: www.vivecomfort.com Hours of Operation: M-F 9 AM – 6 PM Eastern

Applications Guide
The wireless repeater extends the signal range of many of our wireless products. When the TP-W150W receives a coded wireless signal, it repeats it to extend the wireless range of the device.

 Power Type      

• Hardwire (Common Wire) 24V AC (18-30V)

RF Frequency

• 916 MHz916 MHz

A trained, experienced technician must install this product.
Carefully read these instructions. You could damage this product or cause a hazardous condition if you fail to follow these instructions. Patents and Trademarks pending. Copyright © 2013. All rights reserved.

Getting to know the TP-W150W Module

1. Indicator Light
2. LCD
3. Module Button

Important
Wireless modules must have 24VAC power connected to R and C. 

Connecting to Devices

1. When powered, the set Reference Number of communicating devices appears on the LCD.2 To determine the Reference Number needed (1, 2, 3, or 4) for your devices; see the chart below.
2. To enter the Reference Number selection mode, press the Module Button.3 The Reference Number will start flashing. While Flashing, press the Module Button again to select the Reference Number needed. Once Selection is made, stop. The number will quit flashing in 5 seconds, and the Device Reference Number is set.

Select the reference number that corresponds to the devices.

Ref. #   1	Communication Path (Master Thermostat to:) –              Equipment Base Module –              Damper Module	Model Numbers Involved Z955W, Z270W, Z260W
2	–  Zone Thermostat –  Outdoor Remote Sensor –  Discharge Air Sensor	Z955W, S-955WH, Z251W, ZDA250W, ROS-250W, RIS-251W
3	– Equipment Base Module	S-955WH
4	– Equipment Base Module	TP-N-631W

Wireless Module – Installation

Wireless Range
The range between the TP-W150W module and the devices to be repeated is up to 100 feet with no obstructions and up to 50 feet in standard residential construction. The TP-W150W module should be installed between the wireless devices. To extend the range try placing the modules closer together and/or further away from large metal objects.

Installation Tip
Do not install the wireless module in locations:

• That is behind a chimney.
• Where temperature could exceed 120ºF.
• Where exposed to rain or snow.
• Where exposed to extreme hot or cold.
  NOTE: The wireless modules are NOT weatherproof.

Note
The TP-W150W Reference Number is set to 3 in this example.

Mounting the wireless module sub base

For vertical mount put one screw on top and one screw on the bottom. For horizontal mount put one screw left and one screw right.

Warning
All components of the control system and the thermostat installation must conform to Class II circuits per the NEC Code.

Caution: Electrical Hazard
Failure to disconnect the power before beginning to install this product can cause electrical shock or equipment damage.

Wiring Module to Power Supply
The TP-W150W must be hardwired (C and R terminals connected to 24VAC power).

Wiring Note
Turn off power while wiring.

Mount the Wireless Modules
Align the 4 tabs on the subbase with corresponding slots on the back of the wireless modules. Then push gently until the wireless repeater snaps in place.

Note
The wireless modules can be wired from the back or the bottom.

Installation Tip
Do not install the wireless module in locations:

• That is behind a chimney.
• Where temperature could exceed 120°F.
• Where exposed to rain or snow.
• Where exposed to extreme heat or cold.
  NOTE: The wireless modules are NOT weatherproof.

Specifications

• Power source 18 to 30 VAC, NEC Class II, 50/60 Hz for hardwire (common wire)
• Operating ambient +32ºF to +122ºF ( 0º to +50ºC )
• Operating humidity 90% non-condensing maximum
• Frequency 916 MHz
• Dimensions 4.4”W x 4.4 ”H x .75”D

Warranty Registration

Your new wireless repeater has a 5-year limited warranty. You must register your warranty within 60 days of installation. You can register your new product in 2 ways.

1. Go to our website, select warranty registration, and fill out a short registration form.
   – or –
2. Complete the form below and mail it to the address shown.

Warranty Registration
Name: ____________________________
Address: ____________________________
____________________________
City: ____________________________
State: ____________________________
Zip: _____________________
Thermostat Model: _____________________
Date Installed: _____________________

Complete the form and mail it to Thermostat Warranty Registration
1111 S. Glenstone Suite 2-100

Reference:

Download Manual:

VIVE Comfort TP-W150W Thermostat INSTALLATION MANUAL

OTHER MANUALS:

VIVE Comfort TP-W150W Thermostat OPERATIONAL MANUAL

VIVE Comfort TP-W150W Thermostat INSTALLATION MANUAL