SALUS RT310SR Internet Wireless Thermostat Quick Guide

SALUS RT310SR Internet Wireless Thermostat

Introduction

The RT310SR module will switch your appliance on or off in accordance with the temperature set by you. The completed RT310SR series consists of a transmitter – RT310TX thermostat and a Smart Relay SR868.

Product Compliance

This product complies with EMC 2014/30/EU, LVD 2014/35/EU, RED 2014/53/EU and RoHS 2011/65/EU. Full text of the EU Declaration of Conformity on www.saluslegal.com.
868.0-868.6MHz; <13dBm

Safety Information

Use in accordance with the regulations. Indoor use only. Keep your equipment completely dry. Disconnect your equipment before cleaning it with a dry towel.

Button Functions

1. Turn on the LCD backlight
2. Turn On/Off the Frost Mode
3. Increase button
4. Decrease button
5. Test Mode/ Pairing Mode

LCD icons

1. The thermostat is calling for heat
2. The thermostat is in frost mode
3. RF signal
4. The low battery indicator icon
5. Temperature display

DIP switch settings

The DIP Switches can be found on the rear of your thermostat.

Control feature	TPI	Span
Operation	When TPI is selected on DIP switch № 2, the DIP switch № 1 is functional. You can choose the Cycles Per Hour between a lower comfort level (6CPH) and a higher comfort level (9CPH).	When Span is selected on DIP switch № 2, the DIP switch № 1 is not functional. The temperature accuracy of your thermostat is set to ± 0.25 °C.

LED indication Smart Relay

LED State		Description
Red	On	The relay is off.
	Flash	The relay is in pairing mode.
Green	On	The relay is on.
	2 x Flash	The relay is writing pairing code.
Red and Green	Flash alternately	The relay is paired but lost link.
	Flash in different sequence	It indicates the software version after reboot.

Installation – Step 1

1. Electric heater
2. Boiler

The thermostat and the smart relay are pre-paired from the factory if purchased as a pack. If not, follow the thermostat pairing process.

Installation – Step 2

Pairing process

In case you want to add more than one relay, set all relays into pairing mode, including the ones already paired, and start the pairing process. The LED will flash red when the relay is in pairing mode.

Put the thermostat into pairing mode, by pressing the pair button for 3 seconds. After the smart relay is paired with the thermostat, the LED is steadily red.

Test the pairing process

If the thermostat loses connection with the Smart Relay, the Smart Relay goes into fail-safe mode after 30 minutes.

Change temperature

• Actual room temperature
• Setpoint temperature
• By changing the Setpoint (desired) temperature, you are permanently altering your temperature.
• Two seconds timeout
• Actual room temperature

Frost Mode

Frostpoint review

Press the three buttons together for 3 seconds. Use to select dxx parameter, to change a parameter value, and to confirm.

Parameter

dxx	Function	Parameter	Description	Default value
d01	Temperature display increments	0.1 or 0.5°C	Select temperature display increments	0.5°C
d02	Temperature offset	±3.0°C	Calibrate your thermostat temperature	0.0°C
d03	Frost setpoint	5.0-17.0°C	Set the Frost Point Temperature	5.0°C

REFERENCE

Download Manual:

SALUS RT310SR Internet wireless Thermostat Quick Guide

OTHER MANUALS:

SALUS RT310SR Internet wireless Thermostat User Manual

SALUS RT310SR Internet wireless Thermostat Wiring Daigram

SALUS RT310SR Internet Wireless Thermostat Quick Guide