The NEA SMART 2.0 R-Module 230 V is a wireless connection-type radio system that complies with Directive 2014/53/EU. The manufacturer of the product is REHAU AG + Co. The product requires professional knowledge equivalent to officially recognized professions such as electricians or electronics technicians for installation.
The installation must be carried out in accordance with the applicable national regulations and the local guidelines of the electricity supplier. The user manual for the product is available at www.rehau.com/neasmart2.
The electrical installation must be carried out in a voltage-free state. The system is live and can cause danger to life due to electrical voltage. Before opening, always disconnect from the mains and secure all system components so that they cannot be accidentally switched on. Check for the absence of voltage before starting any installation work.
Risk of life through electrical shock! The electrical installation must follow the applicable national standards and guidelines as well as any specific requirements of your local energy supplier. These instructions are intended for use by a qualified person who is holding an official certificate in one of the following professions: electrician or electronics engineer.
Always read the instructions prior to commencing the installation. Connection to the final power supply must only be carried out after the installation is complete.
Hereby, REHAU AG + Co declares that the radio equipment type Nea Smart 2.0 is in compliance with Directive 2014/53/EU. The full text of the EU Declaration of Conformity is available at the following internet address: www.rehau.com/neasmart2
Electrical voltage! Danger to life!
The system is live.
Freely configurable
This document is protected by copyright. All rights based on this are reserved. No part of this publication may be translated, reproduced or transmitted in any form or by any similar means, electronic or mechanical, photocopying, recording or otherwise, or stored in a data retrieval system.
Our verbal and written advice with regard to usage is based on years of experience and standardized assumptions and is provided to the best of our knowledge. The intended use of REHAU products is described comprehensively in the technical product information. The latest version can be viewed at www.rehau.com/TI. We have no control over the application, use or processing of the products. Responsibility for these activities, therefore, remains entirely with the respective user/processor.
Where claims for liability nonetheless arise, they shall be governed exclusively according to our terms and conditions, available at www.rehau.com/conditions, insofar as nothing else has been agreed upon with REHAU in writing. This shall also apply to all warranty claims, with the warranty applying to the consistent quality of our products in accordance with our specifications. Subject to technical changes.
Additional information
© REHAU Industries SE & Co. KG
Rheniumhaus
95111 Rehau
954644 03.2022
DOWNLOAD MANUALS:
REHAU NEA SMART 2.0 Room Thermostat Installation Guide
Johnson Controls T7000e LCD Digital Thermostat Johnson Controls T7000e LCD Digital Thermostat Installation Guide
Honeywell T8635L Microelectronic Communicating Programmable Thermostat Honeywell T8635L Microelectronic Communicating Programmable Thermostat USER’s GUIDE
Hetta HS01RF WIRELESS THERMOSTAT Kit PAIRING INSTRUCTIONS Insert batteries into the Thermostat. Ensure that the…
HEAT-MAT NGT-567-0010 Underfloor Heating Thermostat Menu Introduction The NGT thermostat can switch your underfloor heating…
Honeywell RLV450 PROGRAMMABLE THERMOSTAT READ BEFORE INSTALLING DESCRIPTION * LP appears only for the first…
Honeywell RLV431 Programmable Thermostat Description The RLV431 thermostat can be used to control an electric…