Wall mounting touch screen thermostat for temperature control both in heating and cooling. It performs actions of type 1B and is intended for operating in environments Pollution Degree 2 and Overvoltage Category III (EN60730-1). Thalos has a monochrome backlit display and an input where it is possible to connect an external contact suitable to reduce the setpoint of 3°C.
SAFETY WARNINGS
During product installation and operation it is necessary to observe the following instructions:
TECHNICAL SPECIFICATIONS
Power supply:
Terminals:
LEGEND
During the standard operation the thermostat displays the detected temperature value and the relay status is identified by the symbol
Setpoint modification
Depleted batteries signal
Replace the batteries as soon as possible! Dispose of the batteries in the appropriate recycling containers.
Switch off
Note: in heating mode (winter), if the Thalos is off, it regulates the antifreeze Toff temperature in order to prevent freezing of the system. Toff can have values from 1 to 10° C or be excluded; in this case any minimum temperature is guaranteed
Error messages
Occurs in case of probe failure.
In this case the Thalos activates the receiver for 10 minutes every 4 hours (if the antifreeze temperature Toff is active)
Reset
Unhook and re-hook the thermostat from the base. Press the keys for at least 3 seconds during the flashing.
Default values
To enter menu Advanced programming keep simultaneously pressed for 5 seconds the keys and until PR will appear. The items of the menu are displayed in succession. For each item is displayed an identity breviation and its relative blinking value. Use the keys and to modify the blinking value. After 3 seconds without touching the keys there is the passage to the following parameter. The writing END will appear when all parameters are set and the thermostat returns successively in standard mode saving the effected modifications
Night reduction temperature
Thalos has got an input to whom to connect an external contact (see wiring diagrams). With closed contact, the setpoint is reduced by 3 °C than the set one.
Backlighting management
The display backlighting is normally OFF and it is enabled (blue color) entering menu: setpoint modification, advanced programming, pin enter
ORBIS
DOWNLOAD MANUALS:
Orbis THALOS ELECTRONIC TOUCH SCREEN THERMOSTATS User Manual
OTHER MANUALS:
Orbis THALOS ELECTRONIC TOUCH SCREEN THERMOSTATS Product Specifications Guide
Orbis THALOS ELECTRONIC TOUCH SCREEN THERMOSTATS User Manual
Johnson Controls T7000e LCD Digital Thermostat Johnson Controls T7000e LCD Digital Thermostat Installation Guide
Honeywell T8635L Microelectronic Communicating Programmable Thermostat Honeywell T8635L Microelectronic Communicating Programmable Thermostat USER’s GUIDE
Hetta HS01RF WIRELESS THERMOSTAT Kit PAIRING INSTRUCTIONS Insert batteries into the Thermostat. Ensure that the…
HEAT-MAT NGT-567-0010 Underfloor Heating Thermostat Menu Introduction The NGT thermostat can switch your underfloor heating…
Honeywell RLV450 PROGRAMMABLE THERMOSTAT READ BEFORE INSTALLING DESCRIPTION * LP appears only for the first…
Honeywell RLV431 Programmable Thermostat Description The RLV431 thermostat can be used to control an electric…