NUHEAT NVENT SIGNATURE Programmable THERMOSTAT Quick Start Guide

NUHEAT NVENT SIGNATURE Programmable THERMOSTAT

QUICK START GUIDE

Contents

SETUP AND TROUBLESHOOTING VIDEOS, as well as a complete operating manual is available on nVent.com/NUHEAT

• Loosen screw at the bottom and remove faceplate.
• Do not attempt to remove the screw completely.
• Turn power source OFF at breaker panel. Make electrical connections on power base. DO NOT over tighten the terminal screws. Secure protective cap onto power base.
• The floor sensor cable must be routed to the junction box separate from power wires and the heating cable cold lead.
• Ensure that the insulation on the electrical wiring and the floor sensor inside the junction box are not damaged.
• Push power base into electrical box. Secure power base to wall
• Make sensor connections. Remount faceplate. Do not touch the screen when mounting faceplate onto powerbase.
• Turn power source ON at breaker panel. Perform system tests. Once systems tests are complete, press “Start Using Thermostat” and complete setup wizard.
• Go into Settings > WiFi Settings to connect the thermostat to your
• WiFi network. You will be prompted to provide an email address for account setup. A verification email will be sent containing a link to complete your account setup

CLASSIFICATION

The product is a Class II device (enhanced insulation) and must be connected to the following leads: Phase L1 (L) 120 V, Phase L2 (N) 0/120 V, Max. load 15 A (resistive load) The terminals are suitable for field wiring cables of 12 to 22 AWG. Heating element in accordance with the supply voltage

TECHNICAL DATA

• Supply …………………………………………………………………….120/240 Vac 50/60 Hz
• Load ……………………………………………………………………….max. 15 A (resistive load)
• Power …………………………………………………………………….1800 W at 120 Vac
• ……………………………………………………………………………….3120 W at 208 Vac
• ……………………………………………………………………………….3600 W at 240 Vac
• GFCI ……………………………………………………………………….Class A (5 mA trip level)
• Temperature range …………………………………………………..+5 to +40°C, +41 to +104°F
• Amb. temp. range …………………………………………………….0 to +25°C, +32 to +77°F
• WIFI ……………………………………………………………………….IEEE 802.11 b/g/n
• Contains FCC ID ………………………………………………………2ACSV-HF-LPT230
• Contains IC ID ………………………………………………………….12243A-HFLPT230
• Construction of Control: Electronic room thermostat for regulating electrical underfloor heating.
• Method of Mounting Control: Independently mounted control for flush mounting
• Type of Action …………………………………………………………Type 2.B.
• Rated Impulse Voltage ……………………………………………..2500 V
• Control Pollution Degree …………………………………………..PD2

CERTIFICATION

According to the following standards:

• Thermostat: UL 60730-1
• UL 60730-2-9
• CSA E60730-1:13
• CSA E60730-2-9
• UL file number: E157297
• GFCI: UL 943 4th ed.
• CSA C22.2 No. 144.1-06
• Patent pending

ITEMS

• Change date and time
• Access WiFi settings
• Access weather forecast (WiFi connection required)
• Current temperature
• Target temperature or setpoint
• Heating indicator – when visible, the system is heating.
• Access energy use data
• Access Main Menu
• GFCI test Button
• GFCI Indicator
• On/Off Button
• Press to turn the system ON/Reset GFCI
• Hold to turn the system OFF

WARNINGS

To avoid electric shock, disconnect the heating system power supply at the main panel before installation and maintenance of the thermostat. Keep thermostat air vents clean and free from obstruction. This thermostat is an electrical product and must be installed in compliance with the National and/or Local Electrical Code. Installation must be performed by qualified personnel where required by law

FCC

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

• this device may not cause harmful interference, and
• this device must accept any interference received, including interference that may cause undesired operation.

IC

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:

• this device may not cause interference, and
• this device must accept any interference, including interference that may cause undesired operation of the device

North America

• Tel.: +1.800.778.9276
• Fax: +1.604.529.4404
• res.customercare@nvent.com

Reference

Download Manual:

NUHEAT NVENT SIGNATURE Programmable THERMOSTAT Quick Start Guide

OTHER MANUALS

NUHEAT NVENT SIGNATURE Programmable THERMOSTAT OperationG Manual

NUHEAT NVENT SIGNATURE Programmable THERMOSTAT General Wiring Diagram

NUHEAT NVENT SIGNATURE Programmable THERMOSTAT Product Specifications Guide

NUHEAT NVENT SIGNATURE Programmable THERMOSTAT Quick Start Guide