Meitay-tec ETN24-SUPER-3S-FP-PROG Programmable Thermostat Wiring Diagram

Meitay-tec ETN24-SUPER-3S-FP-PROG Programmable Thermostat

WIRING

DIP switch configuration

Switch	Internal / External sensor		Heat-Cool / Heat Pump		Heater type (HC only)		Heat Pump conf. (HP only)		3 Minutes compressor delay
	Internal*	External	HC*	HP	Electric heat*	Oil/Gas heat	HP in cool*	HP in heat	With delay*	Without delay
1	ON*	OFF	x	x	x	x	x	x	x	x
2	x	x	OFF*	ON	x	x	x	x	x	x
3	x	x	x	x	OFF*	ON	OFF*	ON	x	x
4	x	x	x	x	x	x	x	x	OFF*	ON
5	OFF*	ON	x	x	x	x	x	x	x	x
6	ON*	OFF	x	x	x	x	x	x	x	x

Freeze Protection

When the temperature drops below the freeze protection cut-in temperature*, the thermostat will turn on the Heat and Fan outputs in order to protect the system from freezing. This function will be activated when the thermostat is either in On or Off position. The display will alternate between “AL” and the room temperature. The thermostat will return to normal mode when the temperature rises above the freeze protection cut-off temperature*. *adjustable – refer to the technician settings section of the operating manual

Meitay-tec

• Tel: +972-3-9626462
• Fax: +972-3-9626620
• www.meitavtec.com
• support@meitavtec.com

Reference:

Download manuals:

Meitay-tec ETN24-SUPER-3S-FP-PROG Programmable Thermostat Wiring Diagram

OTHER MANUALS:

Meitay-tec ETN24-SUPER-3S-FP-PROG Programmable Thermostat Product Specification Guide

Meitay-tec ETN24-SUPER-3S-FP-PROG Programmable Thermostat Owner Manual

Meitay-tec ETN24-SUPER-3S-FP-PROG Programmable Thermostat Wiring Diagram