Switch OFF power to your heating/cooling system
Remove old thermostat faceplate and leave wires connected
Label wires Do not label by wire color. Use the supplied sticky tags to label each wire as you disconnect it. Label wires according to old thermostat terminal designations, not by wire color.
Remove wallplate
Remove the old wallplate from the wall after all wires are labeled and disconnected.
Mount wallplate for thermostat
Mount your new wallplate using screws and anchors included with the thermostat.
If necessary:
Connect wires
Important! C wire is required and is the power source. Without a C wire, your thermostat will not power up. See the C Wire Addendum document for more information
Attach thermostat to wallplate
Align the thermostat with wallplate and snap into place.
Switch heating/cooling system ON
Need help?
Visit honeywellhome.com/wifi-thermostat or call 1-855-733-5465 for assistance before returning the thermostat to the store
Select setup
Before connecting to your Wi-Fi network, you need to set initial thermostat options to define your heating/cooling system:
Follow the prompts on the screen to select the appropriate options.
Connect the Wi-Fi network
Note: If you cannot complete this step now, touch I’ll do it later. The thermostat will display the home screen. Complete this process by selecting MENU > Wi-Fi Setup. Continue with Step 2.1b.
Note: If your home network is not shown on the list, touch Rescan.
Note:
Open the Total Connect Comfort website
Go to www.mytotalconnectcomfort.com
Log in or create an account
Note: If you do not receive a response, check your junk mailbox or use an alternate e-mail address.
Register your thermostat
Note:
Connect
Total Connect Comfort free app is GET IT ON available for Apple® iPhone®, iPad® and iPod touch® devices at iTunes® or at Google Play® for all Android™ devices. This thermostat works with common 24 volt systems such as forced air, hydronic, heat pump, oil, gas, and electric. It will not work with millivolt systems, such as a gas fireplace, or with 120/240 volt systems such as baseboard electric heat.
CAUTION:
MERCURY NOTICE: If this product is replacing a control that contains mercury in a sealed tube, do not place the old control in the trash. Contact your local waste management authority for instructions regarding recycling and proper disposal. To avoid possible compressor damage, do not run the air conditioner if the outside temperature drops below 50°F (10°C).
ELECTRONIC WASTE NOTICE: The product should not be disposed of with other household waste. Check for the nearest authorized collection centers or authorized recyclers. The correct disposal of end-of-life equipment will help prevent negative consequences for the environment and human health.
DOWNLOAD MANUAL:
Honeywell Home RTH9600WF Touchscreen Programmable Thermostat User Manual
OTHER MANUAL:
Honeywell Home RTH9600WF Touchscreen Programmable Thermostat User Guide
Honeywell Home RTH9600WF Touchscreen Programmable Thermostat User Manual
Johnson Controls T7000e LCD Digital Thermostat Johnson Controls T7000e LCD Digital Thermostat Installation Guide
Honeywell T8635L Microelectronic Communicating Programmable Thermostat Honeywell T8635L Microelectronic Communicating Programmable Thermostat USER’s GUIDE
Hetta HS01RF WIRELESS THERMOSTAT Kit PAIRING INSTRUCTIONS Insert batteries into the Thermostat. Ensure that the…
HEAT-MAT NGT-567-0010 Underfloor Heating Thermostat Menu Introduction The NGT thermostat can switch your underfloor heating…
Honeywell RLV450 PROGRAMMABLE THERMOSTAT READ BEFORE INSTALLING DESCRIPTION * LP appears only for the first…
Honeywell RLV431 Programmable Thermostat Description The RLV431 thermostat can be used to control an electric…