Honeywell Home T87N Ther Round Thermostat Owner Manual

Honeywell Home T87N Ther Round Thermostat

This manual covers the following models:

• Heat-only T87K
• Heat and Cool T87N

Pre-installation checklist

Check package contents:

• Thermostat
• Wall anchors & screws (2 each)

Before you begin, make sure you have:

• No. 2 Phillips & small pocket screwdrivers
• Hammer
• Level (optional)
• Pencil
• Drill and bit (3/16” for drywall, 7/32” for plaster)

Must be installed by a trained, experienced technician
Read these instructions carefully. Failure to follow these instructions can damage the product or cause a hazardous condition.

CAUTION: ELECTRICAL HAZARD
Can cause electrical shock or equipment damage. Disconnect power before beginning installation.
MERCURY NOTICE
If this product is replacing a control that contains mercury in a sealed tube, do not place the old control in the trash. Contact your local waste management authority for instructions regarding recycling and proper disposal.
This thermostat contains a Lithium battery which may contain Perchlorate material. Perchlorate Material—special handling may apply,
See www.dtsc.ca.gov/hazardouswaste/perchlorate

Product application

This thermostat provides electronic control of:

• 24 VAC heating systems (T87K)
• 24 VAC heating and cooling systems (T87N)

System Types

• Gas or oil heat (T87K)
• Gas, oil, or electric heat with air conditioning (T87N)
• Warm air, hot water, high-efficiency furnaces, heat pumps, steam, gravity
• Heat only
• Heat only with fan (T87N)
• Heat only, 2-wire, and 3-wire hot-water valve (power open and close valves) (T87K)
• Cool only (T87N)

System Settings (T87N)

• Heat, Off, Cool

Fan Settings (T87N)

• Auto, On

Specifications

• Temperature Range: 40° to 90°F (4.5° to 32°C)
• Shipping Temperature: -20° to 120°F (-28.9° to 48.9°C)
• Operating Relative Humidity: 5% to 90% (non-condensing)
• Electrical Ratings
  • Voltage: 20–30 VAC
  • Running current: 0.02–1.0A

Installation tips

Do not install in locations where the thermostat can be affected by:

• Drafts or dead spots behind doors and in corners
• Hot or cold air from ducts
• Sunlight or radiant heat from appliances
• Concealed pipes or chimneys
• Unheated/uncooled areas such as an outside wall behind the thermostat.

Wallplate installation

1. Pull wires through wire hole. Position wallplate on wall, level, and mark hole positions.
2. Drill holes (3/16” for drywall, 7/32” for plaster) and tap in supplied wall anchors.
3. Pull wire through wallplate, position over anchors, then insert and tighten mounting screws. Check level if desired.

Wiring

1. Loosen screw terminals, insert wires into terminal block, then re-tighten screws.
2. Push excess wire back into the wall opening.
3. Plug the wall opening with nonflammable insulation to prevent drafts from affecting thermostat operation.

Terminal Designations—T87N

• W Heat relay.
• Y Compressor contactor.
• G Fan relay.
• O Heat pump changeover valve energized in cooling.
• Rc Cooling power. Connect to secondary side of cooling system transformer.
• R Heating power. Connect to secondary side of heating system transformer.
• B Heat pump changeover valve energized in heating.

NOTES

R & Rc terminals (T87N)
In single-transformer system, leave metal jumper in place between R & Rc. Remove metal jumper if two-transformer system.

Terminal Designations—T87K

• W Heat relay.
• R Power. Connect to secondary side of heating system transformer.
• Y This terminal can be used for some 3-wire hot-water valve systems (power open and close valves).

Heat pump systems (T87N)
If wiring to a heat pump, use a small piece of wire (not supplied) to connect terminals W and Y.

Wire specifications
Use 18-gauge thermostat wire. Shielded cable is not required.

Fan operation settings (T87N)

F: For gas or oil heating systems, leave the fan operation switch in this factory-set position (for systems that control the fan in a call for heat).
E: Change the switch to this setting for heat pump or electric heat systems. (This setting is for systems that allow the thermostat to control the fan in a call for heat, if a fan wire is connected to the G terminal.)

Cycle rate settings

Heating System            Switch 1    Switch 2

Steam or gravity (1 CPH)	On	On
High efficiency warm air (90%+), hot water, or heat pump (3 CPH)	Off	On
Gas or oil warm air (factory setting) (5 CPH)	Off	Off
Electric warm air (9 CPH)	On	Off

Thermostat mounting

Align the slots on the base with tabs on the thermostat, then push gently until the thermostat snaps into place.

Operation

System switch (T87N)

• Cool: Controls the cooling system.
• Heat: Controls the heating system.
• Off: All systems are off.

Fan switch (T87N)

• On: Fan runs continuously.
• Auto: Fan runs only when heating or cooling system is on.

CAUTION: EQUIPMENT DAMAGE HAZARD (T87N)
Do not operate cooling system when outdoor temperature is below 50°F (10°C).

Limited 5-year warranty

Resideo warrants this product, excluding battery, to be free from defects in workmanship or materials, under normal use and service, for a period of five (5) years from the date of first purchase by the original purchaser. If at any time during the warranty period the product is determined to be defective due to workmanship or materials, Resideo shall repair or replace it (at Resideo’s option).

If the product is defective,

1. return it, with a bill of sale or other dated proof of purchase, to the place from which you purchased it; or
2. call Resideo Customer Care at 1-800-468-1502. Customer Care will make the determination whether the product should be returned to the following address: Resideo Return Goods, 1985 Douglas Dr. N., Golden Valley, MN 55422, or whether a replacement product can be sent to you.

This warranty does not cover removal or reinstallation costs. This warranty shall not apply if it is shown by Resideo that the defect was caused by damage that occurred while the product was in the possession of a consumer.
Reside o’s sole responsibility shall be to repair or replace the product within the terms stated above. RESIDEO SHALL NOT BE LIABLE FOR ANY LOSS OR DAMAGE OF ANY KIND, IN- INCLUDING ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING, DIRECTLY OR INDIRECTLY, FROM ANY BREACH OF ANY WARRANTY, EXPRESS OR IMPLIED, OR ANY OTHER FAILURE OF THIS PRODUCT.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so this limitation may not apply to you.
THIS WARRANTY IS THE ONLY EXPRESS WARRANTY RESIDEO MAKES ON THIS PRODUCT. THE DURATION OF ANY IMPLIED WARRANTIES, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED TO THE FIVE-YEAR DURATION OF THIS WARRANTY. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. This warranty gives you specific legal rights, and you may have other rights which vary from state to state. If you have any questions concerning this warranty, please write Resideo Customer Care, 1985 Douglas Dr, Golden Valley, MN 55422 or call 1-800-468-1502.

Accessories

Please contact your distributor to order replacement parts.

• Temperature range stop …………………………………………..Part Number 50010944-001
• Cover plate ………………………………………………………………….Part Number 50000066-001
  (Use to cover marks left by old thermostats.)

Need Help?
For assistance with this product please visit http://honeywellhome.com or call Customer Care toll-free at 1-800-468-1502
Resideo Inc., 1985 Douglas Drive North
Golden Valley, MN 55422
69-1958EFS—04 M.S. 08-19 | Printed in United States
www.resideo.com
This product is manufactured by Resideo Technologies, Inc., Golden Valley, MN, 1-800-468-1502
© 2019 Resideo Technologies, Inc. The Honeywell Home trademark is used under license from Honeywell International Inc. All rights reserved.

REFERENCE

Download Manual:

Honeywell Home T87N Ther Round Thermostat Owner Manual

OTHER MANUALS:

Honeywell Home T87N Range Stops INSTALLATION INSTRUCTIONS

Honeywell Home T87N Ther Round Thermostat Owner Manual