Devireg 8096265 Programmable Thermostat Installation Guide

Devireg 8096265 Programmable Thermostat

Setting up your Devireg 535 programmable thermostat with your devimat system

Selection of sensor type
Power on the thermostat With the front off, with a small screwdriver or pencil press the installation button.

Select the floor sensor
To change the default setting, press and use the arrow buttons to select your choices. Press to accept your choice.
Press for the next setting.
Maximum floor temperature.

• Tiles on timber based floor = 29°C
• Tiles on concrete based floor = 40°C
• Timber covered floors = 27°C (parquet etc. – Please check with floor supplier)

To change this setting, press and use the arrow buttons to select your choice. Press to accept your choice.
Press for the next setting.

Scale

• When selecting Celsius, the display will show the actual temperature at the floor sensor.
• To change this setting, press and use the arrow buttons to select your choice.
• Press to accept your choice.

Press the installation pinhole to exit installation mode.
Put the frame and front back on.

Setting the time
By pressing the, the hours starts flashing – you can now change them with the.Press the again to change the minutes with the .

To finish, press l then

Setting the weekday

Setting the timer periods

The first period bar flashes indicating this is the morning period. By pressing the , the start time of the period starts flashing. You can change it with the arrow buttons in increments of 15 minutes.

• Press the to accept.

The second (day), third (evening) and fourth (night) period bars are set as mentioned above.

Setting the comfort temperature

• By pressing the , the preset comfort temperature starts flashing.
  
• You can change it with the arrow buttons
• Press to accept, then press

Setting the set back temperature (second and fourth period)

• By pressing the , the preset comfort temperature starts flashing, normally this is set to OFF.
• You can change it with the arrow buttons
• Press to accept.

Changing timer program

To change the program:
Keep the button pressed for 2 seconds. The actual program starts to flash. It is now possible to change the program by using the buttonsPress the to accept.

• P1 – Manual mode
  • On constantly 24 hours 7 days a week at set temperature.
• P2
  • Set temperature – twice a day.
• P3
  • Set temperature all day.
• P4
  • Set temperature Monday – Friday twice a day.
  • Saturday – Sunday all day.

Part no.: 001v01 28.06.10

Reference

Download Manual:

Devireg 8096265 Programmable Thermostat Installation Guide

Devireg 8096265 Programmable Thermostat Installation Guide