Danfoss

DANFOSS LX205T TOUCH SCREEN PROGRAMMABLE THERMOSTAT Quick Start Guide

DANFOSS LX205T TOUCHSCREEN PROGRAMMABLE THERMOSTAT

CONTENTS

HOME SCREEN

ITEMS

  • Day and time
  • Current temperature
  • Target temperature or setpoint
  • Heating indicator – when visible, system is heating
  • Next scheduled change
  • Access Main Menu
  • GFCI Test Button
  • On/Off/GFCI Reset Button
  • Press to turn system ON
  • Hold to turn system OFF
  • Press to reset the GFCI

WARNINGS:

  • To avoid electric shock, disconnect the heating system power supply at the main panel before installation and maintenance of the thermostat.
  • Keep thermostat air vents clean and free from obstruction. This thermostat is an electrical device and must be installed in compliance with national and/or local electrical codes. Installation must be performed by qualified personnel where required by law.
  • If a power module with an equipment ground fault protection device (EGFPD) is to be installed where national and/or local electrical codes require a ground fault circuit interrupter (GFCI), a separate GFCI must also be installed.

INSTRUCTION

  • Loosen the screw at the bottom and remove the faceplate.
  • Do not attempt to remove the screw completely
  • Turn the power source OFF at the breaker panel. Make electrical connections to the power base. See Warnings.
  • AWG between 12 and 20.
  • Note! Do not detach the screws from the terminals.
  • When tightening the screws, use a torque of between 0.8 and 1.2 Nm, (0,6 and 0,8 ft.lbs)
  • The floor sensor must not come in contact with electrical wires in the wall and must be routed outside the electrical box.
  • Thread the floor sensor cable through hole in the power base.
  • Push the electrical wires to the back of the electrical box
  • Push the power base into the electrical box.
  • Secure the power base to the wall
  • The Floor sensor has no polarity. Connect it to the terminals C and D.
  • The power module connects to the termianals A and B*
  • Make the sensor connections.
  • Remount the faceplate.
  • Tighten the screw at the bottom.
  • Perform system and GFCI/EGFPD tests. Once thermostat setup is complete, confirm “Your thermostat will start heating the floor” to complete the startup wizard.

CLASSIFICATION

The product is a Class II device (reinforced insulation) and must be connected to the following leads:

  • Phase L1 (L) 120 V
  • Neutral L2 (N) 0-120 V
  • Max. load 15 A (resistive load)
  • The thermostat is intended to be used with underfloor heating.

TECHNICAL DATA

  • Supply Range………………………………………………. 120/240 Vac 50/60 Hz
  • Load ……………………………………………………….max. 15 A (resistive load)
  • Max. power at e.g. ……………………………………………. 1800 W at 120 Vac
  • ………………………………………………………………………. 3120 W at 208 Vac
  • ………………………………………………………………………. 3600 W at 240 Vac
  • UDG4 (GFCI) …………………………………………….. Class A (5 mA trip level)
  • Temperature range ……………………………..+5 to +40°C / +41 to +104°F
  • Amb. temp. range …………………………………. 0 to +25°C / +32 to +77°F

CERTIFICATION

  • UL Listed for the US and Canada
  • According to the following standards:
  • Thermostat: UL 60730-1
  • UL 60730-2-9
  • CSA E60730-1:13
  • CSA E60730-2-9
  • UL file number: E157297
  • UDG4 GFCI: UL 943 4th ed.
  • CSA C22.2 No. 144.1-06

Danfoss

  • 11655 Crossroads Circle
  • Baltimore, MD 21220
  • 1.866.676.8062
  • © 2015 OJ Electronics. All rights reserved.
  • This manual and parts thereof are protected under Danish and international copyright laws

REFERENCE:

DOWNLOAD MANUALS:

DANFOSS LX205T TOUCH SCREEN PROGRAMMABLE THERMOSTAT Quick Start Guide

OTHER MANUALS:

DANFOSS LX205T TOUCH SCREEN PROGRAMMABLE THERMOSTAT Installational Manual

DANFOSS LX205T TOUCH SCREEN PROGRAMMABLE THERMOSTAT Product Specifications Guide

DANFOSS LX205T TOUCH SCREEN PROGRAMMABLE THERMOSTAT Quick Start Guide

wpx_thermostats

Recent Posts

Johnson Controls T7000e LCD Digital Thermostat Installation Guide

Johnson Controls T7000e LCD Digital Thermostat Johnson Controls T7000e LCD Digital Thermostat Installation Guide

1 year ago

Honeywell T8635L Microelectronic Communicating Programmable Thermostat USER’S GUIDE

Honeywell T8635L Microelectronic Communicating Programmable Thermostat Honeywell T8635L Microelectronic Communicating Programmable Thermostat USER’s GUIDE

1 year ago

Hetta HS01RF WIRELESS THERMOSTAT KIT USER MANUAL

Hetta HS01RF WIRELESS THERMOSTAT Kit PAIRING INSTRUCTIONS Insert batteries into the Thermostat. Ensure that the…

1 year ago

HEAT-MAT NGT-567-0010 Underfloor Heating Thermostat USER MANUAL

HEAT-MAT NGT-567-0010 Underfloor Heating Thermostat Menu Introduction The NGT thermostat can switch your underfloor heating…

1 year ago

Honeywell RLV450 PROGRAMMABLE THERMOSTAT USER GUIDE

Honeywell RLV450 PROGRAMMABLE THERMOSTAT READ BEFORE INSTALLING DESCRIPTION * LP appears only for the first…

1 year ago

Honeywell RLV431 Programmable Thermostat User Guide

Honeywell RLV431 Programmable Thermostat Description The RLV431 thermostat can be used to control an electric…

1 year ago