The thermostat is restricted to indoor use only. It should be mounted on an inner wall about 1.5m above the floor in a position where it is readily affected by the changes of the general room temperature with freely circulating air. Avoid mounting on hot surfaces or in damp areas. Do not expose to direct sunlight.
Caution: Turn off the electrical devices and disconnect the supply to the appliances before replacing the batteries. Replace only with the same or equivalent type of batteries. Do not dispose the used batteries with household waste. Refer to your local area for the proper disposal.
Caution:
Switch off the electric source before maintaining the thermostat.We recommend that the maintenance should be performed by trained personnel.
Heating, Cooling Jumper Bridge. When the jumper bridge is connected to the Heater heating function is selected. When the jumper bridge is connected to the Cooling cooling function is selected. If there is no jumper connection selected then the thermostat will not operate.
No heating or cooling control
DOWNLOAD MANUALS:
CELECT DRT1 Electronic Thermostat Instruction Manual
Johnson Controls T7000e LCD Digital Thermostat Johnson Controls T7000e LCD Digital Thermostat Installation Guide
Honeywell T8635L Microelectronic Communicating Programmable Thermostat Honeywell T8635L Microelectronic Communicating Programmable Thermostat USER’s GUIDE
Hetta HS01RF WIRELESS THERMOSTAT Kit PAIRING INSTRUCTIONS Insert batteries into the Thermostat. Ensure that the…
HEAT-MAT NGT-567-0010 Underfloor Heating Thermostat Menu Introduction The NGT thermostat can switch your underfloor heating…
Honeywell RLV450 PROGRAMMABLE THERMOSTAT READ BEFORE INSTALLING DESCRIPTION * LP appears only for the first…
Honeywell RLV431 Programmable Thermostat Description The RLV431 thermostat can be used to control an electric…