ZEN Thermostat User Manual (ZEN-01 / ZEN-02)

ZEN THERMOSTAT ZEN-01 and ZEN-02 Zigbee

INSIDE THE BOX

GETTING STARTED

The Zen thermostat can only be connected to low voltage systems. Before you begin the installation, ensure that you do the following:

1. Turn off your mains supply
   WARNING Extra Low Voltage only. Do not connect to mains voltages. Do not interconnect the outputs of class two circuits
2. Remove the cover from the old unit
3. Check
   Is your system labeled 120V-240V? Do you see thick wires with wire nuts? If you do your system is NOT compatible with ZEN.
   If you’re unsure, please contact your home automation provider or HVAC installer.
4. Begin installation
   If you are certain that your system is low voltage, begin the installation process by visiting the online guide

zenthermostat.com/install
You will need an internet web browser to complete the installation
It takes approximately 45 minutes to get your ZEN thermostat ready to use

QUICK LOOK

 

BASIC OPERATION

ICON GUIDE

 

Some modes may not be enabled by your home automation provider

USER PREFERENCES
Access the user preferences by removing the unit from the wall and center touching to activate options. Touch right or left to scroll through the preferences. Touch up or down to modify a preference. Center touch to confirm.

Caring for your Zen thermostat
Clean with a damp cloth only. Avoid using chemical cleaning agents.

FCC Notice

This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
The transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and any part of your body.
NOTE: THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.

Industry Canada Notice
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

• Model: ZEN-01 Rating: 24VAC, 2A FCC ID: 2ADJL-ZEN01
• IC ID:  12476A-ZEN01 Built in Malaysia Powered by MMB Networks RapidConnect
• Designed in Australia by Planet Innovation THIS PAGE VISIBLE WHEN FOLDED CONCERTINA FOLD

REFERENCE:

Download Manual: ZEN THERMOSTAT ZEN-01 and ZEN-02 Zigbee user manual

ZEN-01

https://device.report/energystar/2358671

ZEN THERMOSTAT ZEN-01 and ZEN-02 Zigbee – Energy Star Certification

ZEN-02

https://device.report/energystar/2358670

ZEN THERMOSTAT ZEN-01 and ZEN-02 Zigbee – Energy Star Certification

ZEN THERMOSTAT ZEN-01 and ZEN-02 Zigbee User Manual