Salus

SALUS RT310 Non-Programmable THERMOSTAT Quick Guide

SALUS RT310 Non-Programmable THERMOSTAT

Introduction

RT310 / RT310RF is a digital room thermostat used to control room temperature. Device launching heating or cooling system by shorting terminal blocks, simultaneously informing the action and showing this information on the LCD display. Before use please read this manual carefully. Use only AA 1.5 V alkaline batteries in the thermostat. Place the batteries into the battery slot located under the cover. Do not use rechargeable batteries.

Product Compliance

Directives: EMC 2014/30/EU, LVD 2014/35/EU, RED 2014/53/EU, and RoHS 2011/65/EU.
Full information is available on the website www.saluslegal.com

Safety Information

Use in accordance with national and EU regulations. Use the device as intended, keeping it in dry condition.
Product for indoor use only. Installation must be carried out by a qualified person in accordance with national and EU regulations.

Technical specification

RT310 RT310RF
Thermostat supply 2 x AA alkaline batteries 2 x AA alkaline batteries
Receiver supply 230 V AC
Thermostat rating max 3 (1) A
Receiver rating max 16 (5) A
Outputs Voltage free

NO / COM /NC terminals

Voltage free

NO / COM terminals

Temperature range 5 – 35°C 5 – 35°C

Button functions

  1. Turn on the LCD backlight
  2. HEAT/COOL modes change or Frost Protection mode activation
  3. Increase button
  4. Decrease button
  5. When in Manual Mode, ON will turn the boiler on
  6. When in Manual Mode, OFF will turn the boiler of
  7. Receiver operates in automatic mode according to the thermostat
  8. Receiver output is controlled by the On/Off slide switch.
Receiver’s LED diode Status Description

Red

Solid light Power on
Flashing Lost connection or pairing mode
Green Solid light System works

LCD Icon Description

  1. Heating Mode ON
  2. Cooling Mode ON/
    Frost Protection Mode ON
  3. RF signal indicator (only in RT310RF)
  4. Low battery status
  5. Temperature unit
  6. Room/setpoint temperature

RT310 Terminals description

Terminal Description
1 – COM Common Terminal
2 – NC Switched Live OFF
3 – NO Switched Live ON

RXRT510 Receiver terminals description

Terminal Description
NO Switch Terminal
COM Common Switch Terminal
L, N Supply (230 V AC)

DIP switches parameters

1 2 Cooling Heating Default value
ON ON Hysteresis +/- 0.25 °C Hysteresis +/- 0.25°C
ON ON Hysteresis +/- 1.5°C Hysteresis +/- 0.5°C
ON OFF Hysteresis +/- 1.0°C TPI 9 CPH
OFF OFF Hysteresis +/- 0.5°C TPI 6 CPH

Wiring diagram

RT310 Wiring diagram

RT310RF Wiring diagram

Note: If you are using the RT310RF pack, the pairing between the thermostat and the receiver is already done!

Change the Setpoint temperature

Frost Protection

The Frostpoint temperature can be reviewed by pressing the UP button once, but can only be changed in Installer Mode.

Heat / Cool mode selection*

The user can change the heating and cooling mode.
NOTE: In cooling mode, the thermostat reports a cooling demand with a 3-minute delay.

* Function available from software version v2.1

Sleep Mode

When Sleep Mode is active all the thermostat functions will be paused.

Pairing the RT310TX thermostat with the RXRT510 receiver

NOTE: IN THE RT310RF SET, THE THERMOSTAT IS FACTORY PAIRED WITH THE RECEIVER!

If you want to pair the thermostat with the receiver again, make sure that the device is disconnected from the power supply and the switches on the receiver are in the AUTO and ON positions.

Installer Mode

dxx Function Parameter value Default value
d01 Temperature display increments 0.1°C or 0.5°C 0.5°C
d02 Temperature offset +/- 3.0°C 0.0°C
d03 Frost Protection setpoint temperature 5.0°C – 17.0°C 5.0°C

Reset of the RT310 thermostat

Press the RESET button (you can use a paper clip), the thermostat will reset and turn on automatically.

RT310TX thermostat reset

Remove the batteries without pressing any button. Wait 2 minutes and insert the batteries again. Your device will be restarted.

When you want to change the batteries your device will use the internal memory to back up your settings. You have 30 seconds to change the batteries before losing your settings.

PRODUCER:
Salus Limited 6/F, Building 20E, Phase 3, Hong Kong Science Park, 20 Science Park East Avenue, Shatin, New Territories, Hong Kong

IMPORTER:
QL CONTROLS Sp. z o.o. Sp. k. ul. Rolna 4, 43-262 Kobielice

www.salus-controls.eu
SALUS Controls is a member of the Computime Group.
Maintaining a policy of continuous product development SALUS Controls plc reserves the right to change the specification, design, and materials of products listed in this brochure without prior notice.

REFERENCE

Download Manual:

SALUS RT310 Non-Programmable THERMOSTAT Quick Guide

OTHER MANUALS:

SALUS RT310 Non-Programmable Thermostat User Manual

SALUS RT310 Non-Programmable Thermostat Wiring Diagram

SALUS RT310 Non-Programmable THERMOSTAT Quick Guide

wpx_thermostats

Recent Posts

Johnson Controls T7000e LCD Digital Thermostat Installation Guide

Johnson Controls T7000e LCD Digital Thermostat Johnson Controls T7000e LCD Digital Thermostat Installation Guide

1 year ago

Honeywell T8635L Microelectronic Communicating Programmable Thermostat USER’S GUIDE

Honeywell T8635L Microelectronic Communicating Programmable Thermostat Honeywell T8635L Microelectronic Communicating Programmable Thermostat USER’s GUIDE

1 year ago

Hetta HS01RF WIRELESS THERMOSTAT KIT USER MANUAL

Hetta HS01RF WIRELESS THERMOSTAT Kit PAIRING INSTRUCTIONS Insert batteries into the Thermostat. Ensure that the…

1 year ago

HEAT-MAT NGT-567-0010 Underfloor Heating Thermostat USER MANUAL

HEAT-MAT NGT-567-0010 Underfloor Heating Thermostat Menu Introduction The NGT thermostat can switch your underfloor heating…

1 year ago

Honeywell RLV450 PROGRAMMABLE THERMOSTAT USER GUIDE

Honeywell RLV450 PROGRAMMABLE THERMOSTAT READ BEFORE INSTALLING DESCRIPTION * LP appears only for the first…

1 year ago

Honeywell RLV431 Programmable Thermostat User Guide

Honeywell RLV431 Programmable Thermostat Description The RLV431 thermostat can be used to control an electric…

1 year ago