Once you have installed the thermostat, follow the instructions below to operate your new thermostat.
Set the HEAT/COOL mode switch to HEAT or COOL. Set the Fan switch to AUTO (automatic).
Statement of use: The 6010 can be used with most 24-volt gas, oil or electric heating systems, zoned heating systems, heat pumps with or without auxiliary heat, or gas millivolt heating systems. It cannot be used with 120-volt heating systems.
Turn the Temperature control to select the desired temperature.
NOTE: If you have a HEAT PUMP with Board auxiliary heat this section applies to your system.
If your Heat Pump malfunctions or cannot maintain your desired temperature you may occasionally need to access the EMER position on the mode switch. This enables your auxiliary heat source and will continue until you turn it off.
Customer Support: 877-505-2353
or Visit our website www.ritetemp-thermostats.com
Printed in China
DOWNLOAD MANUALS:
Ritetemp 8010 Programmable Thermostat Operational Manual
OTHER MANUALS:
Ritetemp 8010 programmable Thermostat Installational Guide
Johnson Controls T7000e LCD Digital Thermostat Johnson Controls T7000e LCD Digital Thermostat Installation Guide
Honeywell T8635L Microelectronic Communicating Programmable Thermostat Honeywell T8635L Microelectronic Communicating Programmable Thermostat USER’s GUIDE
Hetta HS01RF WIRELESS THERMOSTAT Kit PAIRING INSTRUCTIONS Insert batteries into the Thermostat. Ensure that the…
HEAT-MAT NGT-567-0010 Underfloor Heating Thermostat Menu Introduction The NGT thermostat can switch your underfloor heating…
Honeywell RLV450 PROGRAMMABLE THERMOSTAT READ BEFORE INSTALLING DESCRIPTION * LP appears only for the first…
Honeywell RLV431 Programmable Thermostat Description The RLV431 thermostat can be used to control an electric…