MOMIT Bevel Smart Thermostat Installation guide

MOMIT Bevel Smart Thermostat

What is momit Bevel?

Is the NEW smart thermostat with which heating can be control from any mobile device with Bevel App. Due to its integrated design there’s no need of any additional device to prioritize the temperature of any chosen room. Only taking off the thermostat from the magnetized base and moving it from room to room. Thanks to its 360º screen it turns around automatically to show all the information, so it could be placed in any position

How to use it?
Momit Bevel It can be used in two different ways:

• Placed on the wall to replace an old thermostat
• Separated from the magnetic base to carry from room to room to prioritize the temperature.

Before you start you must:
Have Internet connection to perform properly the installation of the devices. Download the Bevel App from Google Play or App Store.

• Install the Gateway, you must connect it to the current through the micro USB cable and power adapter; as well as the router via ethernet cable.
• When the 3 LEDs stop blinking, the Gateway installation will have been completed successfully.
• Register your Gateway in the Bevel App, by capturing the QR code found on the back of the device or manually by entering the serial number found on the device.
• Separate both parts, thermostat (A) and base (B).
• Remove the base lid (B) pressing on its two slots with a screwdriver, then remove the battery plastic strip
• Register the base (B) on the Bevel App and scan the QR code found on the device or by manually entering the serial number.
• If you have a thermostat currently installed, remove it to install the base (B) in its place.
• Place the base (B) on the wall and insert the 2 boiler cables through the lower opening of the base.
• Fix the base (B) to the wall with screws included in the package.
• Connect the 2 wires in the 2 inputs. You can place whichever wire in any of the 2 inputs and then put the base lid (B) back on.
• Remove the thermostat lid (A) and remove the battery plastic strip.
• Register the thermostat (A) on the Bevel App

Technical specifications

Thermostat

• 2 AA batteries
• Temperature and humidity sensor
• Temperature precision ± 0.3ºC
• E-Ink Screen
• Radio communication with Gateway
• Not suitable for outside usage
• Dimensions: 144,55x80x25,35mm
• Weight: 118g

Gateway

• Input 5V (USB)
• Radio communication with the thermostat
• Not suitable for outside usage
• Dimensions: 70x45x20mm
• Weight: 40g

Base

• 2 AA batteries
• Relay:
  • A to 30 VDC
  • 5A to 125 VAC
• Dimensions: 144,55x80x29,63mm
• Weight: 70g

SCREEN

1. Reduce temperature
2. On/Of
3. Increase temperature
4. Indoor temperature
5. Weather forecast
6. Internet conection
7. Batery level
8. Boiler

How the thermostat’s LED Wifi works:

• Connected to momit server.
• Connected to Internet but not to momit server.
• Connected to our gateway but not to internet.
• There’s no internal connection or the display does not communicate with the base

Reference:

DOWNLOAD MANUALS:

MOMIT Bevel Smart Thermostat Installation guide

MOMIT Bevel Smart Thermostat Installation Guide