Battery | 2 x 1.5V AAA Batteries |
Power Supply | 3V⎓ |
Dimensions | 2.40 x 1.84 x 0.86 in / 6.10 x 4.67 x 2.18 cm |
Weight | 0.15 lb / 0.07 kg |
Connectivity | Zigbee™ 3.0 |
Temperature Display Range | 32°–122°F / 0°–50°C
Temperature Display Accuracy: ±1°F during 32°–122°F ±0.5°C during 0°–50°C |
Temperature Increments | 0.1°F / 0.1°C |
Relative Humidity Display Range | 1–99%
Humidity Display Accuracy: ±3% during 20–80% humidity ±5% during 0–99% humidity |
Relative Humidity Increments | 1% |
Max Connectivity Distance | Indoor: 164 ft / 50 m Outdoor: 492 ft / 150 m
Note: Outdoor distance is measured in a straight line without obstacles. |
FCC ID (Inside Battery Compartment) | 2ARBY-AS041S |
Compatibility
Levoit Aura™ Smart Thermostat
General Safety
Connectivity Signal
Humidity Comfort Level
Displays Comfort, Low, or High depending on the humidity that’s detected by the sensor
Comfort | The humidity is between 40% and 60% |
Low | The humidity is below 40% |
High | The humidity is above 60% |
Installation
The Aura Sensor can be used by itself, or with the Aura Smart Thermostat. When using the sensor with the smart thermostat, make sure the sensor is no more than 164 ft / 50 m away from the thermostat If there are obstructions between the sensor and smart thermostat like dividing walls, different floor levels, and furniture, move the sensor closer as these may affect the sensor’s connectivity.
Note:
Hanging the sensor on a wall
Placing the sensor on a flat surface
VeSync App Setup
Connecting the sensor to the VeSync app
Changing the temperature unit
Replacing Batteries
Problem | Possible Solution |
The sensor display does not turn on. | The battery tab in the battery compartment may still be intact. Open the battery compartment and pull the battery tab out, reinsert the batteries, and close the battery compartment. |
The sensor’s batteries may be low. Replace with 2 AAA batteries. | |
The sensor does not show temperature and humidity information. | Make sure the sensor is on and batteries are installed with correct polarity. |
Problem | Possible Solution |
The VeSync app does not show the sensor’s temperature and humidity information. | Restart the pairing process by removing the sensor’s batteries and reinserting them. This will automatically put the sensor in pairing mode (see Connecting the sensor to the VeSync app). |
The sensor does not connect to the thermostat. | Make sure the thermostat and room sensor are added to the same VeSync account. |
Make sure the thermostat and sensor are no more than 164 ft / 50 m away from each other (see Installation). |
Problem | Possible Solution |
The sensor does not connect to the thermostat. | The sensor’s batteries may be low. Replace with 2 AAA batteries. |
Why isn’t my sensor connecting to the VeSync app?
The sensor is offline.
Warranty Information
Product Name | Aura™ Sensor |
Model | LTM-AS041S-WUS |
For your own reference, we strongly recommend that you record your order ID and date of purchase. | |
Date of Purchase | |
Order ID |
Terms & Policy
Arovast Corporation (“Arovast”) warrants this product to the original purchaser to be free from defects in material and workmanship, under normal use and conditions, for a period of 2 years from the date of original purchase. Arovast agrees, at our option during the warranty period, to repair any defect in material or workmanship or furnish an equal product in exchange without charge, subject to verification of the defect or malfunction and proof of the date of purchase
There is no other express warranty. This warranty does not apply:
Arovast will not be liable for indirect, incidental, or consequential damages in connection with the use of the product covered by this warranty. This warranty extends only to the original consumer purchaser of the product and is not transferable to any subsequent owner of the product regardless of whether the product is transferred during the specified term of the warranty. This warranty does not extend to products purchased from unauthorized sellers. Arovast’s warranty extends only to products purchased from authorized sellers that are subject to Arovast’s quality controls and have agreed to follow its quality controls. All implied warranties are limited to the period of this limited warranty. This warranty gives you specific legal rights and you may also have other rights which vary from state to state. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. If you discover that your product is defective within the specified warranty period, please contact Customer Support via support@levoit.com. DO NOT dispose of your product before contacting us. Once our Customer Support Team has approved your request, please return the product with a copy of the invoice and order ID. Every Levoit product automatically includes a 2-year warranty. To make the customer support process quick and easy, register your product online at www.levoit.com/warranty.
This warranty is made by:
Customer Support
If you have any questions or concerns about your new product, please contact our helpful Customer Support Team.
Attributions
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
NOTE: This equipment has been tested and found to comply with the limits for a digital device, pursuant to the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment
FCC RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. To maintain compliance with FCC RF exposure compliance requirements, please follow operation instructions as documented in this manual. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body. The availability of some specific channels and/or operational frequency bands are country dependent and are firmware programmed at the factory to match the intended destination. The firmware setting is not accessible by the end user.
FCC SDOC SUPPLIER’S DECLARATION OF CONFORMITY
Arovast Corporation hereby declares that this equipment is in compliance with the FCC. The declaration of conformity may be consulted in the support section of our website, accessible from www.levoit.com.
DOWNLOAD MANUALS:
Levoit LTM-AS041S-WUS Programmable Thermostat USER MANUAL
Johnson Controls T7000e LCD Digital Thermostat Johnson Controls T7000e LCD Digital Thermostat Installation Guide
Honeywell T8635L Microelectronic Communicating Programmable Thermostat Honeywell T8635L Microelectronic Communicating Programmable Thermostat USER’s GUIDE
Hetta HS01RF WIRELESS THERMOSTAT Kit PAIRING INSTRUCTIONS Insert batteries into the Thermostat. Ensure that the…
HEAT-MAT NGT-567-0010 Underfloor Heating Thermostat Menu Introduction The NGT thermostat can switch your underfloor heating…
Honeywell RLV450 PROGRAMMABLE THERMOSTAT READ BEFORE INSTALLING DESCRIPTION * LP appears only for the first…
Honeywell RLV431 Programmable Thermostat Description The RLV431 thermostat can be used to control an electric…