Hotowell HTW-31-WKT13V Non-Programmable Wireless Room Thermostat
Introduction
This surface-mounted radio thermostat has been developed to be able to switch electric and conventional heating systems on and off using a set temperature and time
Functions
- Large display can be clearly read with the background lighting.
- Easy to fit thermostat and receiver.
- Knob Button make it easy to use, press button to on/off thermostat, turn left/right to adjust the values.
- Non-programmable
- 868Mhz
- White Backlight
- The display shows the set temperature as well as the measured temperature.
- Temperature display in degrees Celsius.
- The thermostat is supplied with a wall-fixing frame, base and a very compact receiver (surface-mounted).
Technical Data
- Thermostat operating voltage: 2 x AA1.5 V, alkaline batteries.
- Backup storage: EEPROM
- Receiver operating voltage: 230 VAC, 50/60 Hz
- Maximum voltage / (ohmic) load: 250 VAC/10 A.
- Frequency: 868 MHz
- Channel selection: By programming the thermostat and the receiver.
- Receiver switch contacts: NO and NC.
- Temperature settings: 5°C ~ 30°C, 0.5°C increments.
- Accuracy: +/- 0.5°C
- Thermostat dimensions: Surface mounted, 135mm x 87.5 mm x 23.2mm.
- Receiver dimensions: Surface mounted, 114mm x 86 mm x30mm.
- Color: White
- IP protection rating: 30.
Temp. Calibration & Channel Pairing
- Temp. Calibration: Turn off thermostat, press ON/OFF button for 3 sec. to calibrate Temp. by pressing “+” and “-“ buttons.
- IP address :
- 1st Press ID study button on the receiver, Green LED light blinking.
- 2nd Turn off Thermostat, Press ON/OFF buttons for 3 sec. a BUZZ voice occurs, the green light stops blinking, IP address shows on the LCD display, the transceiver and thermostat finish pairing.
Wiring Diagram
Dimensions
REFERENCE
DOWNLOAD MANUALS:
Hotowell HTW-31-WKT13V Non-Programmable Wireless Room Thermostat User Manual
Hotowell HTW-31-WKT13V Non-Programmable Wireless Room Thermostat User Manual