Honeywell Home RTH6350 Programmable Thermostat Quick Installation Guide

Honeywell Home RTH6350 Programmable Thermostat

Installation is Easy

• Label wires and remove your old thermostat
• Install and wire your new thermostat
• Set your new thermostat to match your heating/cooling system
  It is preset for the most common system

We are here to help.
Call 1-800-468-1502 for wiring assistance before returning the thermostat to the store.

1. Turn Off Power to the Heating/Cooling System
2. Remove Old Thermostat
   Remove the old thermostat but leave the wallplate with wires attached.
   MERCURY NOTICE: Do not place your old thermostat in the trash if it contains mercury in a sealed tube. Contact your local waste management authority for instructions regarding recycling and proper disposal.
3. Label Wires with Tags
   Label the wires using the supplied wire labels as you disconnect them.
   NOTE: Jumper wire used on old thermostat? If yes, note what letters the jumper connected and review in wiring section.
4. Separate Wallplate from New Thermostat
5. Insert Quick Reference Card
   Insert quick reference card into the slot in back of the thermostat.
6. Mount Wallplate
   Mount the new wallplate using the included screws and anchors.
   Drill 3/32-in. holes for plaster.
   Drill 3/16-in. holes for drywall.
   Use a hammer to tap the anchors into the wall.
7. Connect Wires
   Simply match wire labels.
   Labels don’t match? See page 23.
   Have a Heat Pump system? See pages 24-25.
   We are here to help.
   Call 1-800-468-1502 for wiring assistance.
8. Install Batteries
9. Install Thermostat onto Wallplate
   Install the thermostat onto the wallplate on the wall.
10. Turn Power Back On
    Turn the power back on to the heating/cooling system.
11. If your system type is…
    If your system type is:
    • Single Stage Heat and Cool
      Congratulations, you’re done!
      If your system type is:
    • Multistage Heat and Cool
    • Heat Pump* without Backup Heat
    • Heat Pump* with Backup Heat
    • Heat Only
    • Cool Only

Continue with advanced installation on page 13 to match your thermostat to your system type.
*Heat Pump—an air conditioner that provides cooling in the summer, and also runs in reverse in the winter to provide heating.
If you are not sure of your system type or if you have other questions, call us toll-free at 1-800-468-1502.
This thermostat works on 24-volt or 750 mV systems. It will NOT work on multi-stage heat pump systems or 120/240 Volt systems.

REFERENCE:

Download Manual:

Honeywell Home RTH6350 Programmable Thermostat Quick Installation Guide

other manuals:

Honeywell Home RTH6350 Programmable Thermostat Operating Manual

Honeywell Home RTH6350 Programmable Thermostat Quick Installation Guide