Heatmisser RF-Switch 16A Wireless Electric
RF-Switch 16A – LED/button indication
Installing the RF-Switch 16A
- Using a small screwdriver, slightly loosen the screw located at the base of the RF-Switch. You can then carefully separate the front panel from the back plate.
- Mount the RF-Switch back plate on the back box in the wall, fixing into place using the screws provided.
- Terminate the cables to the RF-Switch as shown in the wiring diagram (section 6).
- Mount the front panel onto the back plate, tighten the retaining screw on the base.
- Switch on the power supply, the power LED will illuminate.
Overriding the RF-Switch 16A output
- To override the output on the RF-Switch, simply press the override button once, the output & LED will be activated.
- To override the output off, press the button once again. The output & LED will turn off.
Pairing the RF-Switch 16A
- On the RF-Switch, press and hold the pairing button for 3 seconds.
- The pairing/override LED will flash to indicate pairing mode is active.
- The pairing method of your wireless thermostat will differ depending on the model.
- Please refer to the instruction manual of your wireless thermostat on how to complete the pairing procedure
Factory Resetting the RF-Switch 16A
- To reset the RF-Switch, follow these steps;
- Press and hold the pairing/override button for 10 seconds.
- During this time the LED on the RF-Switch will flash, then after 10 seconds stay permanently solid.
- Release the button, the reset procedure is complete
Diagram
RF-Switch 16A Wiring Diagram
Reference
Download manual:
Heatmisser RF-Switch 16A Wireless Electric THERMOSTAT INSTALLATION GUIDE
Heatmisser RF-Switch 16A Wireless Electric THERMOSTAT INSTALLATION GUIDE