Frico T10S Electronic Room Thermostat Installation Guide

Frico T10S Electronic Room Thermostat

T10S

Room/floor heating thermostat for public areas 230VAC

CONFIGURATION SWITCH

MODES DESCRIPTION

• This thermostat is specially made for public area (school, office ….)
• Electronic thermostat with savings reduction mode for electrical heating systems.
• Savings reduction by external clock (Pilot wire), equipped with a switch to select comfort, reduction or clock mode.
• Possibility to regulate either the floor or room temperature, or combined (in this case, the floor sensor is used as temperature limiter)
• Relay Output 10A 230VAC

LED INDICATOR

• Red: Heating indication
• Green: Reduction mode by clock (pilot wire)
• Orange: Heating during reduction mode by clock (pilot wire)
• Green blinking:
  • 0.5-second cycle
    => Internal & external sensor failures
  • 1-second cycle
    => Internal sensor failure
  • 2 seconds cycle
    => External sensor failure

TECHNICAL CHARACTERISTICS

Measured temperature precision	±0.1 °C (or 0.2 °F)
Operating temperature	0 °C – 50 °C (or 32 °F – 122 °F)
Setting temperature range	5 °C – 30 °C (or 41 °F – 86 °F)
Floor limiting temperature range	10 °C – 40 °C (or 50 °F – 104 °F)
Regulation characteristics	Proportional band 10min for 2K or Static differential 0.5K
Electrical Protection	Class II – IP30
Power Supply	230VAC +/- 10 %
Output	10A resistive load (AC1), 230VAC
Optional external Floor sensor	NTC (10K Ohms) 3m, RTS01
Software version	V 1.4x

Reference

Download Manual:

Frico T10S Electronic Room Thermostat Installation Guide

Frico T10S Electronic Room Thermostat Installation Guide