EMERSON White-Rodgers 1F89-211 Non-programmable Electronic Digital Heat Pump Thermostat CONFIGURATION AND TYPICAL WIRING DIAGRAMS Guide

EMERSON White-Rodgers 1F89-211 Non-programmable Electronic Digital Heat Pump Thermostat

CONFIGURATION

The following table allows you to customize the options on your Comfort-Set thermostat. Begin by pressing simultaneously the two buttons in step 1.

ELECTRIC/GAS JUMPER (Fan Option)

If your emergency or auxiliary system will energize the blower, then jumper W904, on the thermostat base, must be cut (see figure at left). If your emergency or auxiliary heat system requires that the thermostat energize the fan circuit, do not cut jumper W904.

O/B TERMINAL SWITCH SELECTION

The O/B switch on this thermostat is factory set to the “O” position. This will accommodate the majority of heat pump applications, which require the changeover relay to be energized in COOL. If the thermostat you are replacing or the heat pump being installed with this thermostat requires a “B” terminal, to energize the changeover relay in HEAT, the O/B switch must be moved to the “B” position.

TYPICAL WIRING DIAGRAMS

Other Manual:

EMERSON White-Rodgers 1F89-211 Non-programmable Electronic Digital Heat Pump Thermostat INSTALLATION AND OPERATION INSTRUCTIONS

EMERSON White-Rodgers 1F89-211 Non-programmable Electronic Digital Heat Pump Thermostat CONFIGURATION AND TYPICAL WIRING DIAGRAMS Guide