Adding a Danfoss Icon™ room thermostat to a Danfoss Link™ system se performed using the Danfoss Link™ CC control unit. More information can be found here in the installation manual of the Danfoss Link™ CC controller. Insert the thermostat into the Link™ system following the instructions on the control screen Link™ CC unit and touch the thermostat screen when prompted Icon to switch it to insert mode. In insert mode, on the screen the thermostat will display a moving pattern as shown below:
After successful insertion, a check mark will appear on the thermostat. Press the check mark to exit insert mode. Opening the offer Wake up the thermostat. Touch and hold the button to open the menu (Fig. B). You can switch or confirm the offers with the button. By pressing the se return in the menu.
Offers
ME.1: Performs a connection test with the main controller. Returns a result of the form percentage values 0-100% (80% or higher is very strong connection).
ME.2: Information / version number, can be used to identify the product.
Heating Segment
danfoss.cz
+420 228 887 666
E-mail: zakaznickyservis@danfoss.com
Download manual:
Danfoss Icon Wireless Room Thermostat Installation Guide
Johnson Controls T7000e LCD Digital Thermostat Johnson Controls T7000e LCD Digital Thermostat Installation Guide
Honeywell T8635L Microelectronic Communicating Programmable Thermostat Honeywell T8635L Microelectronic Communicating Programmable Thermostat USER’s GUIDE
Hetta HS01RF WIRELESS THERMOSTAT Kit PAIRING INSTRUCTIONS Insert batteries into the Thermostat. Ensure that the…
HEAT-MAT NGT-567-0010 Underfloor Heating Thermostat Menu Introduction The NGT thermostat can switch your underfloor heating…
Honeywell RLV450 PROGRAMMABLE THERMOSTAT READ BEFORE INSTALLING DESCRIPTION * LP appears only for the first…
Honeywell RLV431 Programmable Thermostat Description The RLV431 thermostat can be used to control an electric…