CARRIER

Carrier SYSTXCCITW01-A Heat Pump Thermostat Support Sheet

Carrier SYSTXCCITW01-A Heat Pump Thermostat

Is a Password Required? NO

How to enter installer set-up (Service Menu)

  • From the Home screen, press “Menu” in the lower right corner
  • An “Options” screen appears with 8 icons. Press the down arrow in the lower right corner to scroll to the second page of options
  • Press and HOLD the “Service” icon (a picture of a baseball cap) located in the upper left corner for 10 seconds until it turns green

Determine system characteristics through T-Stat

  1. From the Service menu (accessed by pressing and holding the service baseball cap icon) press “Service Information”
  2. Select “Service Information” from the “Options” screen
  3. scroll down to “Model/Serial numbers” and press “Enter”. The system information will be displayed.
  4. Press “Back” or “Done” to exit the system information screen

Check Compressor Lockout settings – Carrier refers to this feature as “Heat Source Lockouts- HP Lockout”

  1. From the Service menu (accessed by pressing and holding the service baseball cap icon) press “SETUP”
  2. From the Setup menu, select “Heat Source Lockouts”
  3. Heat Pump Lockout (compressor lockout) is displayed on the left. Verify it is set to “below” 5 degrees, or “None”. This setting is adjustable from 5-55 degrees
  4. Press “Cancel” to return to the previous screen without changing any settings
  5. Do not hit the save button at any time

Check Strip Heat settings – Carrier refers to this feature as “Heat Source Lockouts – Electric Heat Lockout”

  1. From the Service menu (accessed by pressing and holding the service baseball cap icon) press “SETUP”
  2. From the Setup screen, select “Heat Source Lockouts”
  3. Electric Heat/ Furnace Lockout (strip heat or backup heat lockout) is displayed on the right. Verify it is set to a maximum of 35 degrees. This setting is adjustable from 5-55 degrees.
  4. Press “cancel” to return to the previous screen without changing any settings
  5. Do not hit the save button at any time

PTCS Heat Pump Thermostat Support Sheet
Manufacturer: Carrier Infinity Touch Control
Thermostat Models: SYSTXCCITW01-A, SYSTXCCINTN01-A, SYSTXCCITC01

  1. Access Test Mode for testing system at full capacity
  2. From the Service menu (accessed by pressing and holding the service baseball cap icon) press “Check Out”
  3. Beside “Heat Pump”, select “Heating” or “Cooling” depending on the desired test
  4. On all systems except for the Greenspeed series, select the amount of time you wish to run test and push the up arrow to the highest heating or cooling stage available
  5. On the Greenspeed series, select the amount of time you wish to run the test and push the up arrow until it reads 100%
  6. Select “Start”
  7. Wait and listen to ensure that the system sounds as if it has ramped up to full fan speed. This may take a few minutes depending on the indoor unit characteristics
  8. Wait at least 10 minutes before taking static pressure readings and inserting flow plate for Trueflow plate test
  9. Wait at least 20 to 25 minutes before doing temperature split readings for refrigerant test. The longer the system is allowed to run, the more likely it will reach a steady state

Exit Service Menu

  1. To exit the Service menu, press “DONE” in the bottom right hand corner of the screen

Exit Set-Up Menu

  1. Depending on which Setup menu screen you are on, press “BACK” until you reach the main service menu screen
  2. Press “Exit” and you will return to the home screen
    Caution: On the first screen when entering installer set-up mode (service menu), always press “Cancel” rather than “Save” to avoid changing original installer settings.

Resources: Carrier Support: 1-800-227-7437
Sources: Installation Manual: http://www.utcccs-cdn.com/hvac/docs/1009/Public/09/SYSTXCCITC-02SI.pdf

REFERENCE:

Download Manual: Carrier SYSTXCCITW01-A Heat Pump Thermostat Support Sheet

Carrier SYSTXCCITW01-A Heat Pump Thermostat Support Sheet

wpx_thermostats

Recent Posts

Johnson Controls T7000e LCD Digital Thermostat Installation Guide

Johnson Controls T7000e LCD Digital Thermostat Johnson Controls T7000e LCD Digital Thermostat Installation Guide

1 year ago

Honeywell T8635L Microelectronic Communicating Programmable Thermostat USER’S GUIDE

Honeywell T8635L Microelectronic Communicating Programmable Thermostat Honeywell T8635L Microelectronic Communicating Programmable Thermostat USER’s GUIDE

1 year ago

Hetta HS01RF WIRELESS THERMOSTAT KIT USER MANUAL

Hetta HS01RF WIRELESS THERMOSTAT Kit PAIRING INSTRUCTIONS Insert batteries into the Thermostat. Ensure that the…

1 year ago

HEAT-MAT NGT-567-0010 Underfloor Heating Thermostat USER MANUAL

HEAT-MAT NGT-567-0010 Underfloor Heating Thermostat Menu Introduction The NGT thermostat can switch your underfloor heating…

1 year ago

Honeywell RLV450 PROGRAMMABLE THERMOSTAT USER GUIDE

Honeywell RLV450 PROGRAMMABLE THERMOSTAT READ BEFORE INSTALLING DESCRIPTION * LP appears only for the first…

1 year ago

Honeywell RLV431 Programmable Thermostat User Guide

Honeywell RLV431 Programmable Thermostat Description The RLV431 thermostat can be used to control an electric…

1 year ago