Ritetemp-LOGO

Ritetemp 6010 Non-Programmable Thermostat

Ritetemp-6010-non-programmable-ThermostaT-PRODUCT

PRODUCT OVERVIEW

Once you have installed the thermostat, follow the instructions below to operate your new thermostat.

Ritetemp-6010-non-programmable-ThermostaT-FIG.1

Configure

Set the HEAT/COOL mode switch to HEAT or COOL. Set the Fan switch to AUTO (automatic).

Statement of use: The 6010 can be used with most 24-volt gas, oil or electric heating systems, zoned heating systems, heat pumps with or without auxiliary heat, or gas millivolt heating systems. It cannot be used with 120-volt heating systems.

Set Temp

Turn the Temperature control to select the desired temperature.

Operate

Ritetemp-6010-non-programmable-ThermostaT-FIG.2

Heat Pump EMER Switch

NOTE: If you have a HEAT PUMP with Board auxiliary heat this section applies to your system.

If your Heat Pump malfunctions or cannot maintain your desired temperature you may occasionally need to access the EMER position on the mode switch. This enables your auxiliary heat source and will continue until you turn it off.

Ritetemp-6010-non-programmable-ThermostaT-FIG.3

Customer Support: 877-505-2353
or Visit our website www.ritetemp-thermostats.com
Printed in China

REFERENCE:

DOWNLOAD MANUALS:

Ritetemp 6010 Non-Programmable Thermostat Operational Manual

OTHER MANUALS:

Ritetemp 6010 non-programmableThermostat Installational Guide

Ritetemp-LOGO

Ritetemp 6010 Non-Programmable Thermostat Operational Manual

Leave a Reply

Your email address will not be published. Required fields are marked *

Your post must include a link to this post.

How does this work?
Write a response on your own website and include a link to this post. Then submit your response’s URL here. Your response may appear here after moderation. To update or remove it, edit or delete your original post and submit the same URL again. Learn more about Webmentions.