Nuheat Home Touchscreen Programmable Thermostat Data Sheet Guide

Contents hide

1 Nuheat Home Touchscreen Programmable Thermostat Data Sheet

2 HOME SCREEN

Nuheat Home Touchscreen Programmable Thermostat Data Sheet

HOME SCREEN

Nuheat Home Touchscreen Programmable Thermostat Data Sheet fig-1

ITEMS

Change date and time
Current temperature
Target temperature or setpoint
Heating indicator – when visible, system is heating.
Access energy use data
Access Main Menu
GFCI test Button
GFCI Indicator
On/Off Button
Press to turn the system ON/Reset GFCI
Hold to turn the system OFF

TECHNICAL DATA

Supply …..120/240 Vac 50/60 Hz
Load …….max. 15 A (resistive load)
Power …..1800 W at 120 Vac
……3120 W at 208 Vac
……3600 W at 240 Vac
GFCI ……Class A (5 mA trip level)
Temperature range …..+5 to +40°C, +41 to +104°F
Amb. temp. range …..0 to +25°C, +32 to +77°F
Construction of Control: Electronic room thermostat for regulating electrical underfloor heating.
Method of Mounting Control: Independently mounted control for flush mounting
Type of Action:…..Type 2.B.
Rated Impulse Voltage:….2500 V
Control Pollution Degree: …..PD2

WARNINGS:
To avoid electric shock, disconnect the heating system power supply at the main panel before installation and maintenance of the thermostat. Keep thermostat air vents clean and free from obstruction. This thermostat is an electrical product and must be installed in compliance with the National and/or Local Electrical Code. Installation must be performed by qualified personnel where required by law.

QUICK START GUIDE

Nuheat Home Touchscreen Programmable Thermostat Data Sheet fig-2

SETUP AND TROUBLESHOOTING VIDEOS, as well as a complete operating manual, is available on nVent.com/NUHEAT.

Nuheat Home Touchscreen Programmable Thermostat Data Sheet fig-3

Loosen screw at the bottom and remove the faceplate.
Do not attempt to remove the screw completely.

Nuheat Home Touchscreen Programmable Thermostat Data Sheet fig-4

Turn the power source OFF at the breaker panel. Make electrical connections
on the power base. DO NOT over-tighten the terminal screws. Secure protective cap onto the power base.

The floor sensor cable must be routed to the junction box separate from power wires and the heating cable cold lead. Ensure that the insulation on the electrical wiring and the floor sensor inside the junction box are not damaged. Nuheat Home Touchscreen Programmable Thermostat Data Sheet fig-5
Thread floor sensor through a hole in the power base. Push electrical wires to the back of the electrical box.