WUNDA Smart Thermostat User Manual

WUNDA Smart Thermostat

Look out

Located on the device’s face are the energy-saving e-ink display and 3 control buttons:

• – button: a short press decreases the setpoint temperature by 0.1 de-grees, a long press by 1 degree
• + button: a short press increases the setpoint temperature by 0.1 de-grees, along press by 1 degree
• o button: a short press locks/unlocks the weekly table, and a long press activates the pairing of the device

Located on the device’s back are: the removable battery cover and wall bracket.

Safety instructions

Cleaning

• Use only a dry, soft cloth for cleaning.
• The use of water or organic solvents is prohibited.

Battery change

• It is forbidden to recharge an exhausted battery!
• Replace the battery with an identical, fully charged model.
• The battery replacement process is described in the section “Installing the battery”.

Battery disposal

• Radio-controlled system components are powered by LR6 (AA) type batteries.
• When replacing batteries, be sure to dispose of used components properly.
• In accordance with the law in force in a given territory, batteries

Smart Thermostat installation

To install the Smart Thermostat first ensure that your Smart Hub is correctly installed and registered. (See: Smart Hub instructions for installation- Latin & registration process.)

Tools required:

• A smartphone with the WundaSmart App
• Philips screwdriver
• 2 x M2 screws or adhesive tape

Smart Thermostat location
For the best connection between the Smart Thermostat and the Smart Hub, devices should be situated away from any metal obstacles, transformers, engines, fluorescent lamps, microwave devices, refrigerators, and other industrial equipment. To ensure the best measurement results, the Smart Thermostat should be installed away from direct sunlight, draughts, and heat-emitting devices (heaters, radiators, light bulbs).

WARNING!
Don’t mount the device above 2 m over the floor level.

Battery replacement 
Use 2 x1.5V – alkaline battery LR6 (AA) Remove the battery cover and insert two AA batteries. Make sure the batteries are correctly oriented.

WARNING!
Risk of explosion if the battery is replaced by an incorrect type.

Fixing to the wall

1. Disconnect the bracket from the device
2. Using two Screws, fix the bracket to the wall
3. Reconnect the Smart Thermostat to the mounted wall bracket.

Device pairing

1.  Open the WundaSmart application and log in to your device, select a Room in which you wish to install the Smart Thermostat, and then enter the Settings tab.
2.  At the bottom of the settings menu is “Radio Devices”, select Add a new device and then Add Smart Thermostat.
3. You have 30 seconds to pair the Smart Thermostat. Press the O button until paired appears on the display. The sensor has started to operate.

Technical Specification

REFERENCE:

DOWNLOAD MANUALS:

WUNDA Smart Thermostat User Manual

WUNDA Smart Thermostat User Manual