WUNDA Smart Thermostat
Tools required
- A smartphone with the WundaSmart App or a PC/Mac with Internet access
- Phillips screwdriver
- 2 x M2 screws or adhesive tape
Smart Thermostat installation
To install the Smart Thermostat first ensure that your Smart Hub is correctly installed and registered. (See: Smart Hub Installation Guide)
The packaging contains
- Smart Thermostat
- 2 x AAA 1.5V batteries
Manufacturer
- Wunda Group PLC
- Unit 10
- Kingsway Buildings, Kingsway
- Bridgend Industrial Estate,
- Bridgend,
- Glamorgan,
- CF31 3YH
If for any reason you need to return your Wunda Smart products, simply return the product in its orginal box to us at the above address. Any return is subject to our refund policy so please don’t forget to check the terms and conditions. By using Wunda Smart and other Wunda Smart products you agree to our terms and conditions, which can be found on our website www.wundasmart.com
The device appearance
- Located on the device’s face is the energy saving e-ink display, and 3 control buttons:
- 1st button: a short press increases the setpoint temperature by 0.1 degrees, a long press by 1 degree
- 2nd button: a short press locks/ unlocks the weekly table, a long press activates pairing of the device
- 3rd button: a short press decreases the setpoint temperature by 0.1 degrees, a long press by 1 degree
- Located on the device’s back is:
- the removable battery cover and wall bracket.
- the removable battery cover and wall bracket.
Smart Thermostat location
To ensure the best measurement results, the Smart Thermostat should be installed away from direct sunlight, draughts and heat–emitting devices (heaters, radiators, light bulbs
Fixing to the wall
- disconnect the bracket from the device
- using two screws, fix the bracket to the wall
Reconnect the Smart Thermostat to the mounted wall bracket
Device pairing
- Open the WundaSmart application and log in to your device, select a Room in which you wish to install the Smart Thermostat in and then enter the Settings tab.
- At the bottom of the settings menu is “Radio Devices”, select Add a new device and then Add Smart Thermostat.
- You have 30 seconds to pair the Smart
- Thermostat. Press the middle button until paired appears on the display.
- The sensor has started to operate
Battery replacement
- Battery charge status is indicated in the application or on the Smart Thermostat display.
- Remove the battery cover (wall bracket) and remove the empty batteries.
- Insert new batteries as indicated on the housing.
- Reconnect the Smart Thermostat to the mounted wall bracket
Technical data
REFERENCE:
DOWNLOAD MANUALS:
WUNDA Smart Thermostat Installation Guide
