Rolbit C650W Under Floor Thermostat
Introduction
UP TO TWO STAGE HEAT, TWO STAGE COOL
MODE CHANGE OVER
HEAT PUMP OR HEAT/COOL CONFIGURATION
OPERATES FROM 24 VAC
- C650W.S.H.P operates from 24 VAC.
- Flush mounted thermostat.
- Digital mode changes Heat, Cool, Automatic change over and Fan only. Fan operation change On / Auto.
- Fan speed selection.
- Fan On for continuous operation, Auto per demand.
- Heat Pump configuration or Direct configuration.
- Fault input and indication icon on LCD desplay.
- Block terminal 7 screw connector.
Specifications
- Nominal Voltage 24 VAC (50-60 HZ)
- Temperature accuracy ±1°C (±2ºF)
- Differential 1°C (2ºF)
- Dead – Zone 2ºC (5ºF)
- Fan switch rating 1/4H.P. 4 AMPS
- Output rating 10 VA
- Relative Humidity 10% – 90% RH
- Designed and built according to UL / IEC
- Non flammable plastic ABS – V0 94
- Dimensions 118 X 80 mm
WHEN ORDERING USE THE FOLLOWING PART NUMBER
W.S.H.P. Thermostat
C650W W.S.H.P. FLUSH Thermostat
OPERATING FEATURES
- Nominal operating voltage 24VAC.
- Manual and Automatic change over from Cool to Heat.
- Fan ON or AUTO mode.
- One stage compressor.
- R.V. energize on Cooling (0) or on Heating (B).
- Anti short cycle timer – 5 minutes delay will occur at;
- power cutoff.
- switching from heat to cool and vice versa.
- set-point temperature is reached.
- 7 screw terminal connector.
INSTALLATION REQUIREMENTS
- Flexible multi – strand cables.
- Thermostat is to be located in an air-conditioned area.
- Installing on internal walls only.
- Minimum height of 1.5 meter from the floor is required.
OPTIONS
- External sensor to be placed in the return air.
- Limiting of temperature range energy saving.
- Operation on 24 VAC, 110 VAC, 230VAC and 277 VAC.
Contact Us
ROLBIT Ltd. – 9 Drezner St. Segula Industrial Zone 49279, ISRAEL
Tel: 972 3 9067961
F ax: 972 3 9060034
E-mail: [email protected]
http://www.rolbit-thermostat.com
REFERENCE:
DOWNLOAD MANUALS:
Rolbit C650W Under Floor Thermostat USER MANUAL