Ritetemp 8029B programmable Thermostat
Statement of use: The 8029B can be used with most 24-volt gas, oil, or electric heating and air conditioning systems, single-stage heat pumps, or gas millivolt heating systems. It cannot be used with 120-volt heating systems or multistage heat pumps.
Configure
Set the HEAT/COOL mode switch to HEAT or COOL. The unit will display the ambient temperature. Set the Fan switch to automatic.
Set Temp
Turn the Control Knob to increase or decrease the TARGET TEMP. The TARGET TEMP will be displayed when you are adjusting the temp. (The display will return to show the current ROOM TEMP in a few seconds).
Operate
Your thermostat is now in operation.
In the winter, set the HEAT-COOL Mode switch to HEAT to control your heating system.
In the summer, set the HEAT-COOL Mode switch COOL to control your air conditioner.
In spring and fall or when windows are open, you can set the HEAT/COOL Mode switch to OFF.
Setting the FAN Mode switch to AUTO automatically runs your system’s fan during heating and cooling.
Setting the FAN Mode switch to ON runs your system’s fan continuously even without heating or cooling.
Special Features
F0 / C0 Select
Centigrade / Fahrenheit selection. The C/F jumper is on the back of the thermostat control unit it determines which temperature system is displayed on the LCD display.
- To change the F0 / C0 jumper. Separate the control unit from the wall-mounted terminals. Locate the F0 / C0 jumper.
- Select the desired display mode.
- Replace the control unit on the wall and press RESET.
Low Battery
When the batteries are low, the battery icon will come on and flash.
The two AA Batteries in the unit need to be replaced. In some installations, your heater system will stop functioning when the thermostat loses power. Replace batteries as soon as you see this warning. The thermostat setting will remain for 30 seconds while the batteries are removed and replaced.
Rear View of Unit
REFERENCE:
DOWNLOAD MANUALS:
Leave a Reply