Comfortheat MCD4 Programmable Thermostat   FEA

Comfortheat MTC2 Electric & Hydronic Thermostat Operating Manual

Comfortheat

Comfortheat MTC2 Electric & Hydronic Thermostat 

Comfortheat-MTC2-ElectriC&-Hydronic-Thermostat-PRODUCT

A Comfort Heat floor heating system has been installed on your floor. Underfloor heating will warm from the floor up giving you an unparalleled feeling of comfort. This heating system is
controlled by an electronic thermostat that uses a floor sensor for optimum temperature control.

PRIOR TO TURNING ON

The sub-floor and screed have to be fully cured before turning the heating on. For sand & cement screeds you must wait at least 3 weeks before turning on. With Ultra-thin installations, you must wait 2-3 days for the tile glue to cure. When turning on the floor for the first time, increase the floor temperature gradually over 2-3 days.

PRODUCT WARRANTY
TILE CABLE – 10 years
SLAB CABLE – 10 years
CARPET MATS – 5 years
TIMBER MATS – 5 years THERMOSTAT & SENSOR – 2 years

SUGGESTED TEMPERATURE SETTINGS
BATHROOM – 24 ~ 28ºC
LARGE TILED AREA – 21 ~ 22ºC CARPET – 19 ~ 21ºC
TIMBER – 24ºC
SLAB – 21ºC

The MICROTEMP RANGE of electronic thermostats are specifically designed for underfloor heating systems. The thermostat is vertically or horizontally mounted and has a 2pole isolator with 16A output relay.
MTD2 – The MTD2 thermostat is a manual thermostat. You simply switch it on, and set the desired temperature. When the red light is on, the floor is heating. If there is no light, the floor is either off or at selected temperature. A flashing light means there is an error.

TECHNICAL DATA

  • Supply Voltage: 240Vac, 50/60hz
  • Output Relay: 16A SPST, 3600W max
  • Switching Differential: 0.4 degC
  • Built-in Switch: 2 pole 16A
  • Temperature Range: 0/+50 degC
  • Housing/protection: IP20 & IP21
  • Dimensions (HxWxD): 115mm x 84mm x 58mm
  • Sensor Length: 3m
  • Warranty: 2 years
  • Mounted: Vertical/Horizontal/ Flush mounted

Comfort Heat Australia Pty Ltd
www.comfortheat.com.au
[email protected]
p: 02 9979 8600 f: 02 9979 7706

REFERENCE:

DOWNLOAD MANUALS:

Comfortheat MTC2 Electric & Hydronic Thermostat Operating Manual

OTHER MANUALS:

Comfortheat MTC2 THERMOSTAT Wiring Diagram

Comfortheat

Comfortheat MTC2 Electric & Hydronic Thermostat Operating Manual

Comments

Leave a Reply

Your email address will not be published. Required fields are marked *

To respond on your own website, enter the URL of your response which should contain a link to this post’s permalink URL. Your response will then appear (possibly after moderation) on this page. Want to update or remove your response? Update or delete your post and re-enter your post’s URL again. (Find out more about Webmentions.)