Tag: Secure Thermostat
-
Secure SEC_SIR321 Z-Wave thermostat Installational Manual
Secure SEC_SIR321 Z-Wave thermostat Introduction SIR 321 is a Z-Wave® countdown timer that can be used to control immersion heater elements or other electrical appliances rated up to 3 kW. SIR 321 uses Z-Wave radio frequency technology to communicate with network controllers from Secure or other manufacturers. It is a mains-powered device that can also…
-
Secure SEC_SSR303 Z-Wave thermostat Installational Manual
Secure SEC_SSR303 Z-Wave thermostat Quickstart This is a Z-Wave Device for Europe. To run this device please connect it to your mains power supply. To confirm inclusion and exclusion push and hold the network button until the “ON” LED starts flashing. Important safety information Please read this manual carefully. Failure to follow the recommendations in…
-
Secure SEC_STP328 Timer Controlled Thermostat Quick Start Guide
Secure SEC_STP328 Timer Controlled Thermostat Quick Start This is a wireless Actor. For Inclusion and Exclusion press and hold both white buttons on the device until the LED starts flashing. (green ->Inclusion, red -> Exclusion) Please refer to the chapters below for detailed information about all aspects of the usage of the product. What is…
-
Secure SEC_SES301 Z-Wave thermostat Installational Instruction
Secure SEC_SES301 Z-Wave thermostat Introduction SES301 is a battery-powered temperature sensor that uses Z-Wave® technology low-power radio signals to transmit temperature data to a Controller. This product can be included and operated in any Z-Wave network with other Z-Wave certified devices from other manufacturers and/or other applications. All constantly powered nodes within the network will…
-
Secure SEC_ESRT321-5 Z-Wave Thermostat Quick Start Guide
Secure SEC_ESRT321-5 Z-Wave Thermostat Quickstart This is a Z-Wave Device for Europe. To run this device please insert fresh 2 * AAA LR3 batteries. Please make sure the internal battery is fully charged. For Inclusion of Z-Wave devices into the thermostats network do the following steps: Set DIL switch 1 on the back of the…