Comfortheat-MTC-Electric-&-Hydronic-Programmable-Thermostat-FEATURED

Comfortheat MTC Electric & Hydronic Programmable Thermostat Operations Manual

Comfortheat

Comfortheat MTC Electric & Hydronic Programmable Thermostat 

Comfortheat-MTC-Electric-&-Hydronic-Programmable-Thermostat-PRODUCT

MTC Operations Manual

A Comfort Heat floor heating system has been installed on your floor. Underfloor heating will warm from the floor up giving you an unparalleled feeling of comfort. This heating system is controlled by an electronic thermostat that uses a floor sensor for optimum temperature control.

PRIOR TO TURNING ON
The sub-floor and screed have to be fully cured before turning the heating on. For sand & cement screeds you must wait at least 3 weeks before turning them on. With Ultra-thin installations, you must wait 2-3 days for the tile glue to cure. When turning on the floor for the first time, increase the floor temperature gradually over 2-3 days.

PRODUCT WARRANTY

  • TILE CABLE – 10 years
  • SLAB CABLE – 10 years
  • CARPET MATS – 5 years
  • TIMBER MATS – 5 years THERMOSTAT & SENSOR – 2 years

SUGGESTED TEMPERATURE SETTINGS

  • BATHROOM – 24 ~ 28ºC
  • LARGE TILED AREA – 21 ~ 22ºC CARPET – 19 ~ 21ºC
  • TIMBER – 24ºC
  • SLAB – 21ºC

The MICROTEMP RANGE of electronic thermostats is specifically designed for underfloor heating systems. The thermostat is vertically mounted and has a 2-pole isolator with a 16A output relay.
MTC – The MTC thermostat is a manual thermostat. You simply switch it on and set the desired temperature. When the red light is on, the floor is heating. If there is no light, the floor is either off or at a selected temperature. A flashing light means there is an error.

TECHNICAL DATA

  • Supply Voltage: 240Vac, 50/60hz
  • Output Relay: 16A SPST, 3600W max
  • Switching Differential: 0.4 degC
  • Built-in Switch: 2 pole 16A
  • Temperature Range: 0/+50 degC
  • Housing/protection: IP20 & IP21
  • Dimensions (HxWxD): 115mm x 84mm x 58mm
  • Sensor Length: 3m
  • Warranty: 2 years
  • Mounted: Vertically/Flush mounted

Comfort Heat Australia Pty Ltd
www.comfortheat.com.au
[email protected]
p: 02 9979 8600 f: 02 9979 7706

REFERENCE:

DOWNLOAD MANUALS:

Comfortheat MTC Electric & Hydronic Programmable Thermostat Operations Manual

OTHER MANUALS:

Comfortheat MTC THERMOSTAT Wiring Diagram

 

Comfortheat

Comfortheat MTC Electric & Hydronic Programmable Thermostat Operations Manual

Comments

Leave a Reply

Your email address will not be published. Required fields are marked *

To respond on your own website, enter the URL of your response which should contain a link to this post’s permalink URL. Your response will then appear (possibly after moderation) on this page. Want to update or remove your response? Update or delete your post and re-enter your post’s URL again. (Find out more about Webmentions.)